![]() If one of the nodes is rebooted, the invalid entry is cleared out from the unit that has been rebooted. When there is no EMS Fabric Connector configured in FortiOS 6.4.9, 6.4.10, or 6.4.11, and the upgrade is performed directly to 7.0.8, the following is configured with an invalid index ID 0: This creates 5 EMS connector entries as per BUG ID 799987 published in the Release notes below (entries with ID's 1 to 5): ![]() Starting with FortiOS 7.0.8 and 7.2.1, to implement EMS multi-tenancy support, a new syntax is implemented for EMS Fabric Connector. The upgrade path from FortiOS 6.4.9 and higher to 7.0.8 is a direct hop however, there is a known issue that can cause the following behavior:ġ) HA to be out-of-sync because of a mismatch of the configuration under # config endpoint-control fctem s.Ģ) Prevent FortiClient EMS Fabric Connector from being added.ģ) FortiManager policy package installation failure.įirmware upgrade from FortiOS 6.4.9+ directly to 7.0.8 when there is no FortiClient EMS Fabric Connector configured and FortiGate is deployed in HA Cluster (A-P or A-A). ![]() This article describes three issues that may arise after firmware upgrade from 6.4.9+ to 7.0.8. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |